Random questions from all piping components topics, including pipe, fittings, flanges, olets, valves, and gaskets.
You Need a Minimum 70% Score to Pass!!! Try Now
1 / 25
Which type of Globe valve is used in high pressure and other critical services where pressure drop is concerned?
2 / 25
Which type of gate valve is used in slurry and powder product application?
3 / 25
For a non-rising stem valve, the stem will go up while opening the valve and move down when you close the valve.
4 / 25
In the Lift type check valve, the valve disk always remains in the flow path.
5 / 25
Which type of bonnet design is used in the high-pressure applications?
6 / 25
Stop Check Valve is a combination of a lift ________ and _______ .
7 / 25
Which valve is used for regulating and throttling of flow in the pipeline?
8 / 25
________ valve is used in field analog instruments to control flow.
9 / 25
Only seamless pipes are used to produce wrought fittings.
10 / 25
____ is also known as a four-way pipe fitting
11 / 25
Pipe Fittings are available only in butt weld end connections.
12 / 25
Elbows are mainly available in the following types?
13 / 25
In ________, the diameter of the branch is the same as the diameter of the Run (Header) Pipe.
14 / 25
______ is used to change direction as well as reduce the size of the pipeline within a piping system
15 / 25
_______ are not standard pipe fittings and they are fabricated from pipes.
16 / 25
Metallic Gasket dimensions are covered in which standard?
17 / 25
_________ pipes are used when butt type weld fittings are used.
18 / 25
Identify the type of pipe from schedule No. 40S
19 / 25
Which type of pipe is used for critical services such as high pressure?
20 / 25
Which document is used to specify the type of the components that will be used in the given piping system?
21 / 25
The minimum length of Double random pipes is 4.8 meters.
22 / 25
Dimensions of Stainless Steel pipes are given in which standard?
23 / 25
Weldolet is used for taking a branch which is not at 90 degrees to run pipe.
24 / 25
Stub end is the part of which type of flange?
25 / 25
The backing flange in the Lap joint flange can be of a different material than stub end material and usually of carbon steel to save the cost.
The average score is 61%
Restart quiz