/25
7053

Take this 25 Questions Long Quiz and Check Yourself.

Random questions from all piping components topics, including pipe, fittings, flanges, olets, valves, and gaskets.

You Need a Minimum 70% Score to Pass!!! Try Now

1 / 25

Identify the type of gasket shown in the image.

Cam Profile Gasket

2 / 25

Which one is a Non-Metallic gasket?

3 / 25

Spiral Wound Gaskets are painted in accordance with ASME B16.20 for easy identification.

4 / 25

Select two types of metallic gasket that are used with RTJ flanges.

5 / 25

The hardness of the O-ring RTJ gasket shall always be less than flange material by at least ____ BHN.

6 / 25

Identify the type of Valve.

Top-Entry Ball Valve

7 / 25

A dual plate check valve is known as a butterfly check valve.

8 / 25

For a non-rising stem valve, the stem will go up while opening the valve and move down when you close the valve.

9 / 25

Which valve is ideally suited for the handling of slurries, liquids with large amounts of suspended solids, and systems that convey solid material pneumatically?

10 / 25

Which type of disk design in the globe valve provides better throttling?

11 / 25

Which valve is used for regulating and throttling of flow in the pipeline?

12 / 25

Lap flange is available in limited Size of NPS 4” and below.

13 / 25

Which type of Olet is used with the elbow?

14 / 25

__________ type of connection joint in underground piping is not recommended when it is supposed to be buried.

15 / 25

Dimensions of the Carbon & Alloy Steel pipes are covered in the following Standard.

16 / 25

Which document is used to specify the type of the components that will be used in the given piping system?

17 / 25

Which one is not used to indicate pipe size?

18 / 25

Which type of pipe is used for critical services such as high pressure?

19 / 25

What is Small Bore Pipe?

20 / 25

Hydraulic Bulge Method is used to manufacture _______?

21 / 25

______ is used to change direction as well as reduce the size of the pipeline within a piping system

22 / 25

Dimensions of the pipe fittings (Wrought Product (WP)) are given in which standard?

23 / 25

_______ are not standard pipe fittings and they are fabricated from pipes.

24 / 25

In ________, the diameter of the branch is the same as the diameter of the Run (Header) Pipe.

25 / 25

Pipe Fittings are available only in butt weld end connections.

The average score is 62%

0%